METHOD OF APPLICATION

FLOORING system should be installed by approved contractors. Following information should be used as a guideline

1. SURFACE PREPARATION.

The long-term durability of the applied Epoxy PRINIER is dependent on the adhesive bond achieved between the flooring material and substrate. It is most important therefore, that substrate surfaces are correctly prepared prior to application.

•  New concrete or cementitious substrates should have been placed at least 28 days and have a moisture content of less than 5% before topping with EPOXY PRIMER
•  Before application, the surface to be coated, should be free from loose particles, rust, oils, grease, or earlier coatings and should be thoroughly dry.
•  After surface is dry, all repair work like sealing of joints, crack filling of cavities and crevices should be carried out.
•  If the surface is tremix or smooth surface then Shot Blasting is carried out to make the surface rough in order to enhance the bonding of the primer.

2. MIXING

Pack components are pre-weighed for optimum performance. Never split packs. Empty contents of Base into a mixing container and pre-mix to assure the suspension of solids. Add Curing Agent and continue to mix to a uniform consistency for 1-2 minutes. Mix with slow speed drill and helical spinner head for 2 minutes.

3. APPLICATION

EPOXY PRIMER must be applied immediately after mixing the two components. EPOXY PRIMER is applied with a paint brush or roller to produce a thin film.